Harmony 1100 1st Generation LCD
SKU:
$68.00
$44.00 - $62.00
$62.00
On Sale
per item
These modules (Foxconn PT035TN01 V6) include the LCD and integrated touch screen, and are authentic surplus OEM modules, not refurbished counterfeits. The digitizer (aka 'touch screen') ribbon cable is thermally-bonded to the main ribbon unlike aftermarket modules which often have soldered, poorly made connections! Our modules never have any dead or stuck pixels or burned-out backlight LEDs.
We offer two cosmetic options: A-rated modules are in excellent condition with no noticeable wear on the touch screen. B-rated have very minor imperfections on the surface of the screen, usually from handling or storage. Logitech also manufactured these modules using two different digitizers and you can choose the one that you prefer:
In order to ensure the longevity of your LCD, our recommendation is to always 'tap' with the end of the finger with either type. This will reduce the possibility of resistive-layer failure or a cracked screen. Many customers don't realize that these resistive-type digitizers are best used with a stylus and we will provide one with your order. We recommend that the stylus be used at all times, but at a minimum, it should be used during the Calibration Routine, which must be done after the LCD installation. Please note: These modules are not compatible with the 2nd Generation 1100 which uses the Tianma LCD. Only order this LCD if you find the same module in your H1100.
We offer two cosmetic options: A-rated modules are in excellent condition with no noticeable wear on the touch screen. B-rated have very minor imperfections on the surface of the screen, usually from handling or storage. Logitech also manufactured these modules using two different digitizers and you can choose the one that you prefer:
- Sensitive - this digitizer is very sensitive and responds well to being pressed with the the ball of the finger. The top layer tends to be more flexible and has more travel than the 'Normal' version, but the digitizer is also more delicate and prone to resistive-layer failures.
- Normal - this digitizer is less sensitive, but responds well when 'tapped' with the end of the finger, using the tip of the fingernail. The top layer is tighter with less travel and is less prone to resistive-layer failure. However, using excessive pressure by pressing (instead of tapping) can crack these already-firm digitizers.
In order to ensure the longevity of your LCD, our recommendation is to always 'tap' with the end of the finger with either type. This will reduce the possibility of resistive-layer failure or a cracked screen. Many customers don't realize that these resistive-type digitizers are best used with a stylus and we will provide one with your order. We recommend that the stylus be used at all times, but at a minimum, it should be used during the Calibration Routine, which must be done after the LCD installation. Please note: These modules are not compatible with the 2nd Generation 1100 which uses the Tianma LCD. Only order this LCD if you find the same module in your H1100.
Only a few left!